Know the command to enter Ethernet interfaces from the global configuration mode. The command is the interface command, followed by the interface designation. For Ethernet interface 2, it would be interface ethernet 2. The first Ethernet port is always 0.

Know the command to configure an IP address from the Interface Configuration Mode prompt. To set the IP address, use the following command followed by the subnet (this example uses a Class C subnet): ip address 207.12.81.254 255.255.255.0

Key Term and Concept

Interface This command allows you to enter an interface. Use the interface command followed by the interface’s name and number

Related posts:

1. Configure IP Addresses
2. Data link and Network Addresses Exams Points
3. Virtual LANs Exams Points
4. Configure Standard Access Lists to Figure IP Traffic Lab
5. Initial Configuration in Router Using the Setup Command
6. Router Configuration using Setup Command
7. Verify IP addresses Lab
8. Network Addressing Exams Points
9. Classes of IP addresses and subnetting
10. User and Privilege Modes